FORMING — ESG05 order geometry → build-up → gates → export set
NO DESIGN —lites —stack depth —dev worst · all lites —row dilation / law —stroke worst / 1200 —solve
Export gates — decisions are recorded

FR-210 · rollerwave orientation

Roller marks must run in a consistent direction across neighbouring units in the installed condition. Check the drawing (sometimes the 3D file). If the direction must change, cancel and rotate the design — the rotate action lands with the export desk wave.

FR-211 · soft-coating face protection

Build-up surface #1 = the imported file · stack grows inward

01 design
no design loaded — drop an .obj or .stl anywhere on this page
02 build-up
litethicknesssurfacestreatment · odd facetreatment · even face
03 solve
results appear on the Lites & export tab · exporting asks the release questions
The file is read as surface #1 (external face of lite 1) and forms face-down; each lite forms at its own depth in the stack. One pose serves the whole unit — the lites must nest. Export names follow {job}_U{unit}_L{lite}. Coatings per surface feed the FR-211 export gate: a soft (sputtered low-E) coating must never meet the rollers at transition temperature — odd surfaces ride the rollers when forming face-down. Hard (pyrolytic) coatings tolerate contact.

Lites each lite = its own field solve · export gates on the verdict

Jobs store = system of record · re-export = a NEW revision through the gates · this device's ledger below is a cache

device cache per-device ledger — one immutable entry per export; the store above is the truth

—
SOLVING UNIT
starting…